Filter
Top Products
Server Board Installation 51
Attaching the Label to the I/O Shield
1. Remove the backing from the label included with your server board.
2. Press the label onto the outside face of the I/O shield. See Figure 4, A.
OM14360
A
PA
RA
LLEL
KYB
D
MO
U
SE
10
/1
00
M
B
NET
1
2
3
US
B
Figure 4. Attaching the Label to the I/O Shield
Installing the I/O Shield
1. Position one edge so that the dotted groove is outside the chassis wall, and the lip of the shield
rests on the inner chassis wall.
2. Hold the shield in place, and push it into the opening until it is seated. Make sure the I/O shield
snaps into place all the way around.
OM14427
2
1
Figure 5. Installing the I/O Shield