Filter
Top Products
70 Intel Server Board SE7500CW2 Product Guide
Attaching the Heat Sink
1. Align the heat sink with the retention brackets and place the heat sink on the processor.
OM14474
3
3
1
1
Figure 26. Attaching the Heat Sink
2. Position the retention clip over the plastic tab and engage the clip end-slot over the plastic tab.
3. Press downward on the retention clip ends until they engage the plastic tabs.
Installing the Processor Wind Tunnel
Attaching the Processor Wind Tunnel Assembly
Install the processor wind tunnel center section over the heat sink (Figure 27). Note that the plastic
tabs engage the tabs on the retention clips.
OM14475
Figure 27. Attaching the Wind Tunnel Assembly