Filter
Top Products
66 Intel Server Board SE7500CW2 Product Guide
Installing or removing jumpers: A jumper is a small plastic encased
conductor that slips over two jumper pins. Some jumpers have a small tab on
top that you can grip with your fingertips or with a pair of fine needle nosed
pliers. If your jumpers do not have such a tab, take care when using needle
nosed pliers to remove or install a jumper; grip the narrow sides of the
jumper with the pliers, never the wide sides. Gripping the wide sides can
damage the contacts inside the jumper, causing intermittent problems with
the function controlled by that jumper. Take care to grip with, but not
squeeze, the pliers or other tool you use to remove a jumper, or you may
bend or break the stake pins on the board.
Memory
The board supports only DDR 200/266-compliant DIMMs. Install from 256 MB to 4 GB of
memory, using up to four DIMMs.
DIMMs must be installed in pairs. The furthest DIMM pair from the MCH must be populated first.
No DIMM mixing is allowed within a bank. Between banks only the DIMM size may be different.
All DIMMs must be the same speed and architecture. For a list of supported memory, visit the Intel
Support Web site at:
http://support.intel.com/support/motherboards/server/SE7500CW2
OM14194
DIMM Memory Connector 2B
DIMM Memory Connector 3B
DIMM Memory Connector 3A
DIMM Memory Connector 2A
USB
Main Power
Aux. Pwr
DIMM 1A
DIMM 1B
DIMM 2A
DIMM 2B
Figure 22. Installing DIMMs