Filter
Top Products
Chapter 1 — Using the PB50 Mobile Label and Receipt Printer
8 PB50 Mobile Label and Receipt Printer User’s Guide
Using the Batteries
The PB50 uses a rechargeable 2200 mAh lithium-ion battery (Model
AB13) for power. You must fully charge the battery before you can use
the PB50. A fully charged battery can last up to one week without
needing to be recharged when the printer is in Standby mode.
Dispose of used batteries promptly. Keep away from children.
Installing the Battery
Make sure you fully charge the battery before you use your PB50. You
can charge the battery before or after you install them into the PB50.
To install the battery
1 Lay the PB50 upside down on a flat surface.
2 Insert the battery with the tab facing away from the front control
panel.
Use Intermec Model AB13 battery only. Use of another battery
may present a risk of fire or explosion.
The Model AB13 battery may present a fire or chemical burn
hazard if mistreated. Do not disassemble, heat above 100°C
(212°F), or incinerate.