Intermec PB50 Label Maker User Manual


 
Chapter A — Specifications
PB50 Mobile Label and Recept Printer User’s Guide 53
Receipt roll stock media is supplied as a continuous roll. Label, tag,
and fanfold media use repeat indicators for non-continuous media.
Gap, notch, and black marks are used as repeat indicators:
Gap: Label and fanfold media
Notch: Tag media
Black mark: Label, tag, and fanfold media
Here are a few things to keep in mind when ordering media for the
PB50 printer:
Black marks can only be sensed on the back side of the media.
You can use higher caliper media in the printer, but print quality
will be reduced.
Receipt roll stock media has an end of roll indicator. The end of
roll indicator is a red marking (on last 3 feet of roll) on the
thermally sensitive side of the paper.
Media Specifications
Core inside diameter, standard: 19 mm (0.75in)
Core inside diameter, with adapter: 10.2 mm (0.4 in)
Maximum roll outside diameter: 67.3 mm (2.65 in)
Media width, label with liner/receipt: 49mm (1.9 in) to 111.5 mm (4.4 in)
Media length, label: 25.4 mm (1.0 in) to 609.6 mm (24 in)
Media length, receipt: Continuous
Media caliper, label with liner/receipt: 0.05 mm (0.002 in) to 0.165 mm (0.0065 in)
Media caliper, tag (maximum): 0.15 mm (0.006 in)
Gap length (centered on perforation): 3.17 mm (0.125 in) to 12.7 mm (0.50 in)
Notch length (centered on perforation): 6.35 mm (0.25 in)
Notch width (centered on perforation): 12.7 mm (0.50 in)
Black mark length (centered on perforation): 3.17 mm (0.125 in) to 12.7 mm (0.50 in)
Black mark width (centered on media width): Full width of media