Filter
Top Products
Chapter 1 — Using the PB50 Mobile Label and Receipt Printer
PB50 Mobile Label and Receipt Printer User’s Guide 9
3 Insert the edge of the battery under the lip of the PB50 and then
push down until you hear the battery latch click.
Charging the Batteries
There are two ways to charge the PB50 battery:
• Connect AC power to the printer and charge the battery while it is
in the PB50.
• Charge the battery in the AC18 4-bay battery charger.
For information on charging your battery in the 4-bay battery
charger, see the AC18 4-Bay Battery Charger Instructions
(P/N 943-128-xxx).
It takes approximately 6 hours to charge the battery while it is
installed in the PB50 printer. To charge the battery inside the PB50,
you need:
• an Intermec 12 VDC power supply (Model AE19).
• an AC power cord.
To charge the battery inside the PB50
1 Install the battery in the PB50. For help, see the previous section,
“Installing the Battery” on page 8.
2 Connect the power supply to the DC power connector on the
printer.
3 Connect one end of the power cord to the power supply and then
plug the other end into an AC outlet.