Filter
Top Products
13-18
HP Procurve Stack Management
HP Procurve Stack Management
HP Procurve Stack
Management
4. Do one of the following:
• To disable stacking on the Candidate, use the Space bar to select
the
Disabled option, then go to step 5.
Note: Using the menu interface to disable stacking on a Candidate
removes the Candidate from all stacking menus.
• To insert the Candidate into a specific Commander’s stack:
i. Use the space bar to select Member.
ii. Press [Tab] once to display the
Commander MAC Address parameter,
then enter the MAC address of the desired Commander.
• To change
Auto Join or Transmission Interval, use [Tab] to select the
desired parameter, and:
– To change Auto Join, use the Space bar.
– To change
Transmission Interval, type in the new value in the range
of 1 to 300 seconds.
Note: All switches in the stack must be set to the same transmis-
sion interval to help ensure proper stacking operation. HP recom-
mends that you leave this parameter set to the default 60 seconds.
Then go to step 5.
5. press [Enter] to return the cursor to the
Actions line.
6. Press [S] (for
Save) to save your configuration changes and return to the
Stacking menu.
Using the Commander To Manage The Stack
The Commander normally operates as your stack manager and point of entry
into other switches in the stack. This typically includes:
■ Adding new stack members
■ Moving members between stacks
■ Removing members from a stack
■ Accessing stack members for individual configuration changes and traffic
monitoring
The Commander also imposes its passwords on all stack members and pro-
vides SNMP community membership to the stack. (See “SNMP Community
Operation in a Stack” on page 13-45.)