Filter
Top Products
14-22
Port-Based Virtual LANs (VLANs) and GVRP
Port-Based Virtual LANs (Static VLANs)
Port-Based Virtual LANs
(VLANs) and GVRP
(For information on dynamic VLAN and GVRP operation, see “GVRP” on
page 14-30.)
For example, suppose you have a VLAN named VLAN100 with a VID of 100,
and all ports are set to No for this VLAN. To change the VLAN name to
“Blue_Team” and set ports 1-5 to Tagged, you could do so with these com-
mands:
HP4108(config)# vlan 100 name Blue_Team
HP4108(config)# vlan 100 tagged 1-5
To move to the vlan 100 context level and execute the same commands:
HP4108(config)# vlan 100
HP4108(vlan-100)# name Blue_Team
HP4108(vlan-100)# tagged 1-5
Similarly, to change the tagged ports in the above examples to No (or Auto, if
GVRP is enabled), you could use either of the following commands.
At the config level, use:
HP4108(config)# no vlan 100 tagged 1-5
- or -
At the VLAN 100 context level, use:
HP4108(vlan-100)# no tagged 1-5
Note You cannot use these commands with dynamic VLANs. Attempting to do so
results in the message “VLAN already exists.” and no change occurs.
Web: Viewing and Configuring VLAN Parameters
In the web browser interface you can do the following:
■ Add VLANs
■ Rename VLANs
■ Remove VLANs
■ Configure GVRP mode
■ Select a new Primary VLAN
To configure static VLAN port parameters, you will need to use the menu
interface (available by Telnet from the web browser interface) or the CLI.
1. Click on the Configuration tab.
2. Click on [VLAN Configuration].