Filter
Top Products
A-61097 May 1997 3-63
Number of Bar Code Characters
This mode defines the minimum bar code length allowed (in terms of the
number of characters encoded). The default value is 3.
❏ Microimager 70 ■ Microimager 70/AFM ■ Scanner 900
■ Scanner 923 ■ Scanner/Microimager 990 ■ Scanner 9500
1. Select # of Bar Code Characters.
Mode Configuration
Don't Save & End Session
End Configuration
Save & End Session
Previous Menu
Mode Number: 10 Mode Name: MODE10
Bar Code Reading Status
Bar Code Type
# of Bar Code Characters
Bar Codes per Document
Distance Between Codes
Scan Direction
Image Processing
Partial Read Enabled
Min. Partial Characters
DSA Patch Reading Status
Patch Horizontal Location
End Fed Patch Read Status
Level Change via Bar Code
Previous Menu
Bar Code Reader
Enter Minumum Length
Range: 03 - 80 Characters
03
MODE 10
3 Lvl
Supprs
4233
2112
None
Auto
Duplex
?????
1 Roll
Comic
Off
Off
Off
Xport
Off
Undef
Undef
Off
Off
Off
Lvl 2
Off
N N N
Off
On
Disply
Off
Off
Off
Off
No Sav
F
Mode Name
Index Format
IA Display Format
IA Field Widths
Level Rules
Batching
AEC Mode
Film Mode
Reduction Ratio
# of Cassettes
Film Writer
Image Mgmt Code
Length Monitor
Skew Monitor
Check Stacker
Endorser
Not Used
Ftswitch Pressed
Ftswitch Released
Ftswitch Cnf Tone
Patch Reader 1
Patch Reader 2
Patch Definition
Bar Code
Confirmation Tone
OCR Status
COIN User Channel
Printer Control
Primary DP-1
Secondary DP-1
Doc. Printer 12
Document Sorter
Mode Overrides
Film Definition
2. Select the desired minimum length within the range 3 - 80.