Filter
Top Products
A-61097 May 1997 3-65
Distance Between Codes
This mode defines the minimum bar code height allowed. The height of
the tallest bar code determines the distance between codes. The default
value is 1.000 inch/25.400 mm.
❏ Microimager 70 ■ Microimager 70/AFM ■ Scanner 900
■ Scanner 923 ■ Scanner/Microimager 990 ■ Scanner 9500
1. Select Distance Between Codes.
Mode Configuration
Don't Save & End Session
End Configuration
Save & End Session
Previous Menu
Mode Number: 10 Mode Name: MODE10
Distance between bar codes
must be greater than height
of largest bar code.
*** HINT ***
Always add one “click” to
height of largest code.
*** NOTE ***
Distance Between Codes
1.000
25.400 mm Default
Press ENTER to return
to Previous Menu.
0.375 in.
9.53 mm
3.000 in.
76.20 mm
MODE 10
3 Lvl
Supprs
4233
2112
None
Auto
Duplex
?????
1 Roll
Comic
Off
Off
Off
Xport
Off
Undef
Undef
Off
Off
Off
Lvl 2
Off
N N N
Off
On
Disply
Off
Off
Off
Off
No Sav
F
Mode Name
Index Format
IA Display Format
IA Field Widths
Level Rules
Batching
AEC Mode
Film Mode
Reduction Ratio
# of Cassettes
Film Writer
Image Mgmt Code
Length Monitor
Skew Monitor
Check Stacker
Endorser
Not Used
Ftswitch Pressed
Ftswitch Released
Ftswitch Cnf Tone
Patch Reader 1
Patch Reader 2
Patch Definition
Bar Code
Confirmation Tone
OCR Status
COIN User Channel
Printer Control
Primary DP-1
Secondary DP-1
Doc. Printer 12
Document Sorter
Mode Overrides
Film Definition
2. Select the desired bar code height/distance between codes within the
range 0.375 inch to 3 inches or 9.53 mm to 76.20 mm by pressing the
left/right arrow key(s) to decrement/increment the default value by
0.125 inch or 3.18 mm at a time.