Filter
Top Products
3-84 A-61097 May 1997
Special Character Set
This mode defines the size font to be printed. Select either the smaller or
larger font size when using the Document Printer 12. The default value is
Use Smaller Font.
NOTE: This selection is not available if the wrong printer driver board is
installed. The following message appears:
Incorrect revision of 3100 PCB for Bigfoot Font
❏ Microimager 70 ■ Microimager 70/AFM ■ Scanner 900
■ Scanner 923 ■ Scanner/Microimager 990 ■ Scanner 9500
1. Select Special Character Set.
Printer Control
Mode Configuration
Don't Save & End Session
End Configuration
Save & End Session
Previous Menu
Mode Number: 10 Mode Name: MODE10
Field
Character Set
MODE 10
3 Lvl
Supprs
4233
2112
None
Auto
Duplex
?????
1 Roll
Comic
Off
Off
Off
Xport
Off
Undef
Undef
Off
Off
Off
Lvl 2
Off
N N N
Off
On
Disply
Off
Off
Off
Off
No Sav
F
Mode Name
Index Format
IA Display Format
IA Field Widths
Level Rules
Batching
AEC Mode
Film Mode
Reduction Ratio
# of Cassettes
Film Writer
Image Mgmt Code
Length Monitor
Skew Monitor
Check Stacker
Endorser
Not Used
Ftswitch Pressed
Ftswitch Released
Ftswitch Cnf Tone
Patch Reader 1
Patch Reader 2
Patch Definition
Bar Code
Confirmation Tone
OCR Status
COIN User Channel
Printer Control
Primary DP-1
Secondary DP-1
Doc. Printer 12
Document Sorter
Mode Overrides
Film Definition
IA Print Format
Print Position
Special Character Set
Previous Menu
Use Smaller Font
Use Larger Font
Previous Menu
2. Select the desired font size.