Filter
Top Products
A-61097 May 1997 3-75
Patch Detected Tone
NOTE: Patch reading must be enabled. In addition, the confirmation
tones must have been enabled during machine definitions;
otherwise, this definition will be ignored.
This mode enables or disables a confirmation tone issued when a patch
document is detected. The default value is Off or Disabled.
❏ Microimager 70 ■ Microimager 70/AFM ■ Scanner 900
■ Scanner 923 ■ Scanner/Microimager 990 ■ Scanner 9500
1. Select Patch Detected Tone.
Confirmation Tone
Mode Configuration
Don't Save & End Session
End Configuration
Save & End Session
Previous Menu
Mode Number: 10 Mode Name: MODE10
FieldPatch Tone
MODE 10
3 Lvl
Supprs
4233
2112
None
Auto
Duplex
?????
1 Roll
Comic
Off
Off
Off
Xport
Off
Undef
Undef
Off
Off
Off
Lvl 2
Off
N N N
Off
On
Disply
Off
Off
Off
Off
No Sav
F
Mode Name
Index Format
IA Display Format
IA Field Widths
Level Rules
Batching
AEC Mode
Film Mode
Reduction Ratio
# of Cassettes
Film Writer
Image Mgmt Code
Length Monitor
Skew Monitor
Check Stacker
Endorser
Not Used
Ftswitch Pressed
Ftswitch Released
Ftswitch Cnf Tone
Patch Reader 1
Patch Reader 2
Patch Definition
Bar Code
Confirmation Tone
OCR Status
COIN User Channel
Printer Control
Primary DP-1
Secondary DP-1
Doc. Printer 12
Document Sorter
Mode Overrides
Film Definition
Patch Detected Tone
Bar Detected Tone
Bar Code/Patch Tone
Previous Menu
Off or Disabled
On or Enabled
Previous Menu
2. Select the desired status.
NOTE: If the Patch Detected Tone is enabled, the Bar Code/Patch Tone
cannot be enabled. However, the Bar Detected Tone may be
enabled.