Filter
Top Products
A-61097 May 1997 3-21
Reduction Ratio
This mode defines the level of magnification. The default value is Don’t
Care.
❏ Microimager 70 ■ Microimager 70/AFM ❏ Scanner 900
❏ Scanner 923 ■ Scanner/Microimager 990 ❏ Scanner 9500
1. Select Reduction Ratio.
Reduction Ratio
Don't Care
24x
40x
50x
Previous Menu
Mode Configuration
Don't Save & End Session
End Configuration
Save & End Session
Previous Menu
Mode Number: 10 Mode Name: MODE10
Don't Save & End Session
End Configuration
Save & End Session
Previous Menu
Mode Name: MODE10
MODE 10
3 Lvl
Supprs
4233
2112
None
Auto
Duplex
?????
1 Roll
Comic
Off
Off
Off
Xport
Off
Undef
Undef
Off
Off
Off
Lvl 2
Off
N N N
Off
On
Disply
Off
Off
Off
Off
No Sav
F
Mode Name
Index Format
IA Display Format
IA Field Widths
Level Rules
Batching
AEC Mode
Film Mode
Reduction Ratio
# of Cassettes
Film Writer
Image Mgmt Code
Length Monitor
Skew Monitor
Check Stacker
Endorser
Not Used
Ftswitch Pressed
Ftswitch Released
Ftswitch Cnf Tone
Patch Reader 1
Patch Reader 2
Patch Definition
Bar Code
Confirmation Tone
OCR Status
COIN User Channel
Printer Control
Primary DP-1
Secondary DP-1
Doc. Printer 12
Document Sorter
Mode Overrides
Film Definition
2. Select the desired reduction ratio.
Use the following information to determine the reduction allowed
based upon the Film Mode selected:
— If the film mode is Simplex, you may select 50X, 40X, or 24X.
— If the film mode is Duplex, you may select 50X or 40X.
— If the film mode is Duo, you may select 50X or 40X.
NOTE: This selection is not available on the scanners.