Filter
Top Products
2-8 A-61097 May 1997
The following default values apply only to the Scanner/Microimager 990:
DefinitionKey
P1
P2
P3
P4
P5
P6
P7
P8
P9
P10
f04,2
f45
f09
f08
f37
f30
f44
f46
f07
f98f38
Count only, toggle
Print test
Total document count
Last Image Address
Calibrate
Amount of film remaining
Omit printing on next document only
Print position
Level 0
Stop, End-of-Job
To enter a function code, type an f (lower case) followed by a two-digit
code (i.e., f04). Any additional information, such as a zero (0) to disable a
function, a one (1) to enable a function, or a two (2) to toggle a function, is
entered by typing a comma (,) followed by the additional information (i.e.,
f04,1 enables counting only).
Multiple function codes are entered as a string of individual function codes
with no spaces or delimiters in between (i.e., f98f38 stops the machine
and then issues an end-of-job indicator).
When using a Microimager 70 without the Advanced Function Module
installed, only two of the P-Keys are programmable: P5 and P10.
When using a Microimager 70 with the Advanced Function Module
installed, Scanner 900, Scanner 923, Scanner/Microimager 990, or
Scanner 9500, all P-Keys are programmable.
P-Keys are programmed using the following sequence of steps:
1. Select a P-Key (P1 – P10).
2. Press Return/Enter.
3. Enter the desired function.
Repeat this sequence for each P-Key you wish to (re)program.