Filter
Top Products
A-61097 May 1997 3-71
Patch Horizontal Location
This mode defines the position of patches on the document(s) in terms of
the distance from the left side of the transport. The default value is
5.12 inches/130.048 mm.
❏ Microimager 70 ■ Microimager 70/AFM ❏ Scanner 900
■ Scanner 923 ■ Scanner/Microimager 990 ■ Scanner 9500
1. Select Patch Horizontal Location.
Bar Code Reader
Mode Configuration
Don't Save & End Session
End Configuration
Save & End Session
Previous Menu
Mode Number: 10 Mode Name: MODE10
Bar Code Reading Status
Bar Code Type
# of Bar Code Characters
Bar Codes per Document
Distance Between Codes
Scan Direction
Image Processing
Partial Read Enabled
Min. Partial Characters
DSA Patch Reading Status
Patch Horizontal Location
End Fed Patch Read Status
Level Change via Bar Code
Previous Menu
Bar Code Patch Position
5.120
130.048 mm Default
Press ENTER to return
to Previous Menu.
1.92 in.
48.77 mm
9.60 in.
243.84 mm
MODE 10
3 Lvl
Supprs
4233
2112
None
Auto
Duplex
?????
1 Roll
Comic
Off
Off
Off
Xport
Off
Undef
Undef
Off
Off
Off
Lvl 2
Off
N N N
Off
On
Disply
Off
Off
Off
Off
No Sav
F
Mode Name
Index Format
IA Display Format
IA Field Widths
Level Rules
Batching
AEC Mode
Film Mode
Reduction Ratio
# of Cassettes
Film Writer
Image Mgmt Code
Length Monitor
Skew Monitor
Check Stacker
Endorser
Not Used
Ftswitch Pressed
Ftswitch Released
Ftswitch Cnf Tone
Patch Reader 1
Patch Reader 2
Patch Definition
Bar Code
Confirmation Tone
OCR Status
COIN User Channel
Printer Control
Primary DP-1
Secondary DP-1
Doc. Printer 12
Document Sorter
Mode Overrides
Film Definition
2. Select the desired location within the range 1.92 to 9.6 inches or
48.75 mm to 243.84 mm by pressing the left/right arrow key(s) to
decrement/increment the default value by 0.64 inch or 16.25 mm at a
time.