Filter
Top Products
2
Connecting to a Computer
2-2
2.2 Connecting the Network Cable
Insert the connectors on the network cable into the network ports.
✎
Note
This connection is available only with FAX3900.
Be sure to use a shielded Category 5 or 5E network cable. Use of
an unshielded cable may result in radio frequency interference.
1 Insert the connector on one end of the network cable into the network
port as shown in the illustration.
2 Insert the connector on the other end of the network cable into an
available port on the network hub.
About the LEDs
LED1 (LINK): This LED lights up when the network cable is
connected correctly. If this LED is not lit, check
the connection again, even if the copier appears
to be connected correctly. If this LED is not lit
when both ends are connected correctly, the
network cable may be damaged.
LED2 (ACT): This LED blinks when data is being transferred.