Filter
Top Products
LaCie Biggest Quadra
User Manual
page 22
Setting Up the Biggest Quadra
is is the default setting of the LaCie Biggest
Quadra. Follow these steps to set the RAID level at
RAID 5.
Power off the LaCie Biggest Quadra.
Move switch 1 and 2 of the RAID Level Switch Se-
lectors to the OFF position.
1.
2.
4.1.1. RAID 5■
CAUTION: In a RAID 5 array, in the event
that a disk needs to be replaced, always replace the
failed disk with the LaCie Biggest Quadra’s power
on. Do not turn the LaCie Biggest Quadra’s power
off; doing so may lead to the loss of the data on
the array.
ImpOrTANT INfO: In a RAID 5 + Hot
Spare array, the disk in the top drive bay is desig-
nated as the Hot Spare (the default setting), and
the Disk Status Indicator will light in amber to
indicate this configuration.
Power off the LaCie Biggest Quadra.
Move switch 1 of the RAID Level Switch Selectors
to the OFF position. Move switch 2 of the RAID
Level Switch Selectors to the ON position.
1.
2.
4.1.2. RAID 5 + Hot Spare■
TeChNICAl NOTe: In the initial configura-
tion of a RAID 5 + Hot Spare array, the top drive
bay (Drive Bay 1) is the default Hot Spare (the Disk
Status Indicator will be amber). In the event that a
disk fails, the Hot Spare position will change.
For example, if the disk in Drive Bay 3 fails, then
the Hot Spare disk in Drive Bay 1 will be re-built
and will no longer be the Hot Spare. Instead,
when you place a new disk in Drive Bay 3, it will
become the new Hot Spare, and will be indicated
by the amber Disk Status Indicator.
Fig. 4.1.1
Fig. 4.1.2