Filter
Top Products
5: Commands and Levels
PremierWave XN Command Reference 150
show history
Displays the last 20 commands entered during the current
CLI session.
show line
Displays the current configuration.
show statistics
Shows the line statistics.
state disable
Disables the line so data cannot be sent/received.
state enable
Enables the line so data can be sent/received.
stop bits 1
Uses one stop bit after data on the line.
stop bits 2
Uses two stop bits after data on the line.
terminal <line>
Enters the configure-terminal level.
<line> = number of the terminal line (serial port) to be con-
figured.
terminal network
Enters the configure-terminal level for the network.
termination disable
Refrains from terminating the line.
termination enable
Enables 120 ohm line termination in RS485 half-duplex
mode.
threshold <bytes>
Sets the threshold in bytes. After this many bytes are re-
ceived, they are
forwarded without delay.
tunnel <line>
Enters the tunnel level.
<line> = number of the tunnel line (serial port) to be confi-
gured.
write
Stores the current configuration in permanent memory.
xoff char <control>
Sets the xoff character for use with software flow control
on this line.
The character may be input as text, control, decimal, or
hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
xon char <control>
Sets the xon character for use with software flow control
on this line.
The character may be input as text, control, decimal, or
hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
link (config-wlan:wlan0) level commands
active channel scan time <milliseconds>
Sets the active channel scan time in milliseconds.
apply wlan
Try out WLAN settings without saving them to Flash.
If the settings do not work, when you reboot the device,
it will still have the original settings.
cancel wps
Cancels wi-fi protected setup operation.
choice <instance>
Enters the next lower level.
Specify the instance for the next lower level.
clrscrn
Clears the screen.
debugging level debug
Sets the WLAN debugging level to Debug.
debugging level dump Sets the WLAN debugging level to Dump, the most ver-
bose option.
debugging level error
Sets the WLAN debugging level to Error, which shows
only errors.
debugging level info
Sets the WLAN debugging level to Info.
debugging level warning
Sets the WLAN debugging level to Warning.
default active channel scan time
Restores the default active channel scan time.
default debugging level
Sets the WLAN debugging level to its default value, Info.