Filter
Top Products
5: Commands and Levels
PremierWave XN Command Reference 55
start character
is received on the line.
default connect mode
Restores the default connect mode as "disable".
default host mode Connects to the first host in the list that accepts the con-
nection.
default local port
Uses a random port number as the local port for establish-
ing tunneling
connections to other devices.
default reconnect time
Restores the default reconnect time value for connect
mode tunneling.
default start character
Defaults the connect mode start character.
email connect <number>
Sets an email profile to use to send an email alert upon
establishing
a connect mode tunnel.
<number> = the number of the email profile to use.
email disconnect <number>
Sets an email profile to use to send an email alert upon
closing
a connect mode tunnel.
<number> = the number of the email profile to use.
exit
Returns to the tunnel level.
flush serial disable
Characters already in the serial data buffer are retained
upon establishing
a connect mode tunneling connection.
flush serial enable Flushes the serial data buffer upon establishing a connect
mode tunneling
connection.
flush start character disable Enables forwarding of the connect start character into the
network.
flush start character enable
Disables forwarding of the connect start character into the
network.
host <instance>
Enters the next lower level.
Specify the instance for the next lower level.
host mode sequential Connects to the first host in the list that accepts the con-
nection.
host mode simultaneous
Selects simultaneous connections to all hosts on the host
list.
kill connection Disconnects the active connect mode tunneling connec-
tion or connections.
local port <number>
Sets a specific port for use as the local port.
<number> = the number of the port to use.
no email connect
Discontinues sending email alerts upon establishing a
connect mode tunnel.
no email disconnect Discontinues sending email alerts upon closing a connect
mode tunnel.
promote host <number>
Promotes the identified host, exchanging it place with the
host above it,
to adjust the order of the defined hosts.
reconnect time <milliseconds>
Sets the reconnect time value for tunneling connections
established by the
device in milliseconds.
<milliseconds> = timeout in milliseconds.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current
CLI session.
show status
Displays tunnel connect status.