Filter
Top Products
5: Commands and Levels
PremierWave XN Command Reference 151
default out of range scan interval Restores the default value to the out-of-range scan inter-
val (30 sec).
default passive channel scan time Restores the default passive channel scan time.
default radio band selection Sets the radio band selection to its default value, Dual.
default rssi delta Restores the RSSI delta value to the default value (24
dBm).
exit Exit back to interface configuration level
out of range scan interval <seconds> This setting determines the interval (in seconds) between
scans for access points to which the unit might roam.
This setting only applies when roaming is enabled.
Note: The more frequent the scans, the greater the im-
pact on data throughput.
passive channel scan time <milliseconds> Sets the passive channel scan time in milliseconds.
radio band selection 2.4 ghz only Sets the radio band selection to 2.4 GHz Only.
radio band selection 5 ghz only Sets the radio band selection to 5 GHz Only.
radio band selection dual Sets the radio band selection to Dual.
roam status Show roaming status
roaming disable Disables roaming.
roaming enable Enables roaming to other Access Points with the same
SSID.
rssi delta <dBm> Sets the RSSI delta value.
scan <ssid> Scan the radio environment for networks.
show Displays the current configuration.
show history Displays the last 20 commands entered during the current
CLI session.
show wps information Show the configuration received by wi-fi protected setup.
show wps information with secrets Show the configuration received by wi-fi protected setup
with secrets.
show wps status Show status of WPS operation.
start wps Starts wi-fi protected setup operation.
status Show link status
write Stores the current configuration in permanent memory.
link (config-ethernet:eth0) level commands
clrscrn Clears the screen.
default duplex Restores the default duplex setting, which is auto.
default speed Restores the default speed setting, which is auto-
negotiate.
duplex auto Sets duplex mode to auto.
duplex full Sets duplex mode to full.
duplex half Sets duplex mode to half.
exit Exit back to interface configuration level
show Displays the current configuration.
show history Displays the last 20 commands entered during the current
CLI session.
speed 10 Sets the speed of the Ethernet link to 10 Mbps.
speed 100 Sets the speed of the Ethernet link to 100 Mbps.
speed auto Sets the speed of the Ethernet link to auto-negotiate.
write Stores the current configuration in permanent memory.
log (config-diagnostics-log) level commands
clrscrn Clears the screen.
default max length Restores the factory default maximum Log file size.