Filter
Top Products
LaserSpeed 8000-3 Instruction Handbook
Ethernet Communication
Part No. 93463 / Drawing No. 0921-01561 Page 170 of 221 Revision A (Sep 2007)
Telnet Example using DHCP
An easy way to connect to the LS8000 over the network is to use a telnet
terminal. There are many telnet terminals available. This example uses the
telnet program that is included with Windows XP.
1
StartRun
2
Type "cmd" and
click OK
3
At the command prompt, type:
"telnet ls9000-test" <ENTER>
4
Type commands just as if you were connected to a RS-232 or RS-422 terminal.
Manually Configured IP Address
To manually assign an IP Address, disable DHCP, then set the IP Address.
This can be done with LaserTrak, or by entering commands over the RS-232
or RS-422 ports. If you are using a LAN, contact your system administrator to
reserve an IP Address, or a block of addresses for use with instrumentation.