Filter
Top Products
Enabling the Relays
Use the [6]=ENABLE CIRCUITS function to enable or disable the master clock’s con
-
trol relays during circuit wiring or maintenance. This function can also hold back clocks
to manually adjust for daylight saving time in the fall if the daylight saving function is
not in use (see Setting Daylight Saving Time on page 2-7). The ENABLE CIRCUITS
function only enables the relays; it does not turn them on. See Manually Activating Bell
Controls on page 2-6 to turn on the relays.
Enter the administrative password as shown on page 2-2, then follow the key sequences
below:
Press Display
[#] SELECT FUNCTION CODE
[6] [6]=ENABLE CIRCUITS
[#] SELECT ACTIVE
BELL ZONES 12345678
CLOCK CKTS
PRESS [#] IF CORRECT
[1]...[8] Enter the circuit numbers that you want to enable or disable by
toggling the numbers; when you see all the circuits you want
enabled on the display, press [#].
[#] PRESS [#] TO CONFIRM
2-4
24A715/24A715M Master Clock Installation Manual