Filter
Top Products
– Start Power Manager.
– Click the Power scheme tab, and then select Maximum Performance from the predened power
schemes.
• Problem: When I turn on the machine, nothing appears on the screen and the machine does not beep
while starting up.
Note: If you are not sure whether you heard any beeps, turn off the computer by pressing and holding
the power switch for 4 seconds or more. Turn it on and listen again.
Solution: Make sure that:
– The battery is installed correctly.
– The ac power adapter is connected to the computer and the power cord is plugged into a working
electrical outlet.
– The computer is turned on. (Turn the power switch on again for conrmation.)
If a power-on password is set:
– Press any key to display the prompt for the power-on password. If the brightness level of the screen is
low, increase it by pressing the Fn+Home.
– Type the correct password and press Enter (refer to Power-on password).
If these items are properly set, and the screen remains blank, have the computer serviced.
• Problem: When I turn on the machine, only a white cursor appears on a blank screen.
Solution: If you have modied a partition on your hard disk drive by using a partition software, information
about that partition, or the master boot record may have been destroyed.
1. Turn off the computer, and then turn it on again.
2. If you still see only the cursor on the screen, do the following:
– If you have used the partition software, examine the partition on the hard disk drive by using the
software, and recover the partition if required.
– Use either the Rescue and Recover workspace or the recovery discs to restore the system to the
factory state. For details about restoring the system to the factory state, see “Performing backup
and recovery operations” on page 83.
If the problem persists, have the computer serviced.
• Problem: My screen goes blank while the computer is on.
Solution: Your screen saver or power management may be enabled. Do either of the following:
– Move the TrackPoint or the touch pad, or press a key to exit the screen saver.
– Press the power switch to resume from sleep (standby) or hibernation.
Memory problems
Print these instructions now and keep it with your computer for reference later.
If your memory is not operating properly, check the following items:
1. Verify that the memory is installed and seated correctly in your computer.
It may be necessary to remove all added memories to test the computer with only the factory-installed
memories, and then reinstall the memory one at a time to ensure a proper connection. For the
procedures to remove and reinstall a memory, refer to “Replacing the memory” on page 91.
2. Check for error messages during startup.
162 User Guide