Filter
Top Products
Changing or removing the power-on password
To change or remove the power-on password, follow the steps 1 through 7 above in “Setting a power-on
password” on page 70.
Note: When you press F1 to enter the BIOS Setup Utility, the system will require the power-on password.
Type your power-on password and press enter, then the BIOS Setup Utility window opens.
To change the power-on password, do the following:
1. In the Enter Current Password eld, type the current power-on password.
2. When the Enter New Password eld opens, type a new password in the eld and then retype it to verify.
To remove the power-on password, do as follows:
1. In the Enter Current Password eld, type the current power-on password.
2. When the Enter New Password eld opens, leave it blank and press Enter twice.
Hard disk passwords
Two types of hard disk passwords help protect the information stored on the hard disk:
• User hard disk password
• Master hard disk password, which requires a user hard disk password
If a user hard disk password has been set, but no master hard disk password has been, the user must enter
the user hard disk password in order to gain access to les and applications on the hard disk.
The master password can be set and used only by a system administrator. Like a master key, it enables the
administrator to get access to any hard drive in a system. The administrator sets the master password; no
one else knows it. Then the administrator sets a user password for each computer in the network, and tells
each user the password for his or her computer. The user can then change the user password as desired,
but the administrator can still get access by using the master password.
Setting a hard disk password
1. Print these instructions.
2. Save all open les, and exit all applications.
3. Turn your computer off and then on again.
4. When the logo screen is displayed, press F1. The BIOS Setup Utility opens.
5. Select Security, using the cursor directional keys to move down the menu.
6. Select Password.
7. Select Hard Disk x Password, where x is the number of the hard disk drive for which you want to
set a password.
8. A password window opens. You are prompted to select User or User + Master. Select User if you want
to set only one hard disk password. If you are an administrator or supervisor, you can select User +
Master to set two passwords. (The user can change the user password later.)
9. If you select User + Master, go to step 12.
10. If you select User only, a new-password window opens. Type your new password in the Enter New
Password eld.
Notes:
• If the Passphrase function is enabled, you can choose your hard disk password, which can consist of
1 to 64 characters in any combination. If the Passphrase function is disabled, you can choose a hard
Chapter 4. Security 71