Filter
Top Products
Too many trays attached [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra trays.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Tray [x] paper size unsupported
Replace with a supported paper size.
Unformatted flash detected [53]
Try one or more of the following:
• From the printer control panel, touch Continue to stop the defragmentation and continue printing.
• Format the flash memory.
Note: If the error message remains, then the flash memory may be defective and needs to be replaced.
Unsupported camera mode, unplug camera and change mode
The camera mode does not support PictBridge.
Unplug the camera, change the mode and plug the camera back into the printer.
Unsupported disk
Remove the unsupported printer hard disk, and then insert a supported one.
Unsupported option in slot [x] [55]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the unsupported option card from the printer controller board, and then replace it with a supported card.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
USB port [x] disabled [56]
From the printer control panel, touch Continue to clear the message.
Notes:
• The printer discards any data received through the USB port.
Troubleshooting 288