Filter
Top Products
11
Using printer menus
Custom Types
This menu selection is used to define a name for each custom paper type. You can assign names using a utility such as MarkVision
Professional or from the control panel.
Universal Setup
This menu selection is used to specify the height and width of the Universal Paper Size. By specifying the height and width for Universal
Paper Size, the printer will use the Universal setting exactly like other paper sizes, including support for duplex and n-up.
Card Stock Loading Properly handles preprinted card stock
whether the job is a duplexed or single-
sided job
Duplex
Off*
Shown if Card Stock is supported in the
specified input source.
Custom <x> Loading Properly handles preprinted custom
paper whether the job is a duplexed or
single-sided job
Duplex
Off*
Shown if the custom type is supported in
the specified input source.
Menu selection Purpose Values
Custom Type <x> Specifies the type of paper associated
with each Custom Type available in the
Paper Type menu
Paper*
Card Stock
Transparency
Labels
Envelope
The custom type media must be supported
in the input source you designate in order
to assign a user-defined name.
Once the name is assigned, the name
(truncated to 16 characters) will be
displayed instead of Custom Type x.
Menu selection Purpose Values
Units of Measure Determines the unit of measure used to
enter the Universal Height and Width
Inches* (US)
Millimeters* (non-US)
Inches is the US default; Millimeters is the
international default.
Portrait Width Sets the portrait width of the universal
media
Note: If the value set exceeds the
maximum width, the printer will use the
maximum value allowed in inches or
millimeters.
3 inches to 14.17 inches
in 0.01 inch increments*
(US)
76 mm to 360 mm in 1
mm increments* (non-
US)
Shows either inches or mm from Units of
Measure setting; 8.5 inches is the US
default, and 216 mm is the international
default.
Portrait Height Sets the portrait height of the universal
media
Note: If the value set exceeds the
maximum height, the printer will use the
maximum value allowed in inches or
millimeters.
3 inches to 14.17 inches
in 0.01 inch increments*
(US)
76 mm to 360 in 1 mm
increments* (non-US)
Shows either inches or mm from Units of
Measure setting; 14 inches US default, and
355 mm is the international default.
Feed Direction Specifies the feed direction Short Edge*
Long Edge
Long Edge is only shown if the longest
edge is shorter than the Maximum Physical
Width of the printer.
Menu selection Purpose Values