Filter
Top Products
21
Using printer menus
PCL Emulation
Settings
Specifies the font pitch for scalable
monospaced fonts
Point Size:
1...1008
in increments of 0.25
points) (*12)
Point size refers to the height of the
characters in the font. One point equals
approximately 1/72 of an inch. You can
select point sizes from 1 to 1008 in
increments of 0.25 points.
Point Size is only displayed for
typographic fonts.
Specifies the font pitch for scalable
monospaced fonts
Pitch:
0.08–100.00 (10*)
Pitch refers to the number of fixed-space
characters in a horizontal inch of type.
You can select a pitch from 0.08 to 100
characters per inch (cpi) in increments of
0.01 cpi. For nonscalable monospaced
fonts, the pitch is displayed but cannot be
changed.
Note: Pitch is only displayed for fixed, or
monospaced, fonts.
Determines how text and graphics are
oriented on the page
Orientation:
Portrait*
Landscape
Portrait prints text and graphics parallel to
the short edge of the paper.
Landscape prints text and graphics
parallel to the long edge of the paper.
Determines the number of lines that
print on each page
Lines per Page:
1–255
60* (Americas)
64* (non-Americas)
The printer sets the amount of space
between each line (vertical line spacing)
based on the Lines per Page, Paper Size,
and Orientation menu items. Select the
correct Paper Size and Orientation before
changing Lines per Page.
Sets the width of the logical page for A4
size paper
A4 Width:
198 mm*
203 mm
Note: The 203 mm setting makes the
logical page wide enough to print eighty
10-pitch characters.
Specifies whether the printer
automatically performs a carriage return
after a line feed control command
Auto CR after LF:
Off*
On
Off—Printer does not perform a carriage
return after a line feed control command.
On—Printer performs a carriage return
after a line feed control command.
Specifies whether the printer
automatically performs a line feed after a
carriage return control command
Auto LF after CR:
Off*
On
Off—Printer does not perform a line feed
after a carriage return control command.
On—Printer performs a line feed after a
carriage return control command.
Menu selection Purpose Values