Filter
Top Products
MAKE SURE THE PRINTER SOFTWARE IS INSTALLED ON THE DESTINATION COMPUTER
Fax troubleshooting
•
“Fax troubleshooting checklist” on page 155
• “Cannot send faxes” on page 156
• “Cannot receive faxes” on page 157
•
“Cannot run the fax software” on page 158
•
“Fax error messages on the printer control panel” on page 158
For detailed descriptions of common terms and tasks, see the following:
•
“Setting up the printer to fax” on page 73
•
“Faxing FAQ” on page 90
Fax troubleshooting checklist
If you encounter problems sending and receiving faxes, then check the connection first:
1 Check for a dial tone on the telephone line by plugging an analog telephone into the wall jack, DSL filter, VoIP device,
or cable modem where you connected the printer. Make sure you plug the telephone into the same port.
If you do not hear a dial tone, then contact your line provider.
2
While the printer is connected to the telephone line, check for a dial tone by plugging an analog telephone into the
port of the printer.
If you do not hear a dial tone, then use the checklist below. Listen for a dial tone after checking each item.
If you hear a dial tone but still have problems sending and receiving faxes, then see the other topics in this section.
Connection checklist
•
Make sure that the printer and other devices on the line (if applicable) are set up and configured correctly according
to your setup scenario.
•
Make sure that the cables are connected to the correct ports.
•
Make sure that the cables are securely plugged in.
Check the cable connections for the following hardware, if applicable:
Power supply
Answering machine Cable modem Splitter
Telephone VoIP adapter DSL filter RJ‑11 adapter
• If the printer is connected to a Digital Subscriber Line, then make sure you are using a DSL filter for the printer.
• If the printer is connected to a VoIP adapter or cable modem, then make sure that the printer is plugged into the
first phone port.
• If you are using a splitter, then make sure that you are using a phone splitter. Do not use a line splitter.
Troubleshooting 155