Filter
Top Products
Overview of the Lexmark E120n operator panel
32
Using the operator panels
Programming engine code or system code
Restoring factory defaults
Cartridge region mismatch
Light sequence:
• Ready / Data—On
• Error—On
Message:
New code is being programmed into the engine or firmware.
Solution:
Wait for message to clear. When printer has finished programming the code, it returns to ready.
Note: No buttons are active while this message is displayed.
Light sequence:
• Continue—On
• Ready / Data—On
• Toner Low/Replace PC Kit—On
• Load / Remove Paper—On
• Paper Jam—On
• Error—On
Message:
Printer is resetting to the original factory default settings.
Solution:
Wait for message to clear.
Light sequence:
• Toner Low/Replace PC Kit—Blinking
• Error—Blinking
Message:
The toner cartridge being used is not programmed for the specific region.
Solution:
Remove the toner cartridge, and install a new toner cartridge that is programmed for the same region as your
printer. See the back of the printer for a label with your printer region location. See Ordering supplies on page 66
for a list of correct supplies and part numbers.