Filter
Top Products
25
3.6 Activating Saved Option Changes
You may need to power the printer Off and On to activate an option change. See the
section below, which corresponds to your "attachment" method.
LAN Attachment
Most changes to IPDS MENU settings are active on the very next IPDS print job. This
is true when you are LAN attached using a MarkNet S, MarkNet Pro, or MarkNet XLe
adapter. When the IPDS Timeout option is set to a value other than Host Controlled,
you will have to power the printer Off and On to activate some menu setting changes.
See note below.
Coax/Twinax Attachment
If you are attached to your host using a coax or twinax connection, most settings do not
become active until the printer is powered Off and On. You should power the printer
Off and On, if you want the settings to be used for your next print job.
Note: If you are LAN attached with the IPDS Timeout option set to a value
other than Host Controlled or if you are using a coax or twinax
attachment, the warning message below is displayed if changes do not take
effect immediately.