Filter
Top Products
After you have Shut down completely, it’s time to power-up again
As your system comes up, if PCI cards are installed in the expansion
chassis, you may be prompted to load or locate drivers. Follow the
instructions you see on the screen and install the drivers just as you
would on a desktop computer. (You should refer to the procedures for
installing drivers that was included with the third-party PCI device(s) you
are installing.) If prompted to reboot, do so.
Verify Installation
Go to Start Settings Control Panel System Devices You
should see a device called MrtCb listed as shown below:
MAGMA CardBus Driver installation is complete. You should now
proceed to Step Eight in Chapter Two: Quick Start Guide
.
NOTE
A utility called
PCIScope
is also useful for verification and debugging
purposes. See Page 32 for more information.
WARNING
After installation of a new Microsoft Service Pak, you should always
reinstall the MAGMA CardBus Driver.