Filter
Top Products
Page 19
Press Print (F3) to print test results. See Printing Autotest Results for more information. Note:
The Print (F3) key is unavailable when viewing the AUTOTEST RESULTS screen via the
Extended Functions/Memory feature.
Press Tests (F4) to view a PASS/FAIL summary of test results and to view results for selected
tests. See Viewing Autotest Results Summary for more information.
Viewing Autotest Results
WIRE MAP, LENGTH, PROPAGATION DELAY, NEXT, ATTENUATION, ACR, IMPEDANCE,
LOOP RESISTANCE, CAPACITANCE
You can view Autotest results by pressing View (F1) from the AUTOTEST RESULTS screen and
pressing the
Ñ or Ò arrow key to scroll through test results. Press the ESCAPE key to exit.
The next section describes each test, including how to set test limits, how to read results screen and
how to troubleshoot test results.
Wire Map
Wire Map easily diagnoses your communications link for crossed pairs, shorts, split pairs and opens.
Crossed pairs occur when two or more wires are reversed from end to end, thus resulting in a
communication failure.
Split pairs occur when physical continuity is maintained but wires from logical pairs are split up.
This error is more difficult to detect because there is still a pin-to-pin correspondence. Wire Map
finds split pairs, and you can also suspect split pairs if the cable’s NEXT test result is less than 22
dB. For more information, refer to Microtest’s Category 5 Cable Testing Handbook.
Wire Map Test Results
To display this screen, press View (F1) from the AUTOTEST RESULTS screen, then press the
Ò key until the WIRE MAP TEST RESULTS screen is displayed.
The wire map screen displays a graphical representation of the wiring in your cable. Near end
wiring displays on the left side of the screen and far end wiring displays on the right side of the
screen.
• A >< between wire pairs indicates a crossed pair.
• No line between wire pairs indicates an open.
• A ] between wire pairs indicates a short.
• A straight line between pairs indicates a good pair.
• “PASS” or “FAIL” indicates if wiring is correct or incorrect.
Press Splits (F1) to display the SPLIT PAIRS screen, with the split status displayed to the right of
the wire pair.
Press the Ò arrow key to display the next test result screen or press the ESCAPE key to exit.
Note: You can also generate a wire map by attaching the Injector to the far end of the twisted pair
cable and pressing the Find Cable Faults key.