Filter
Top Products
Notes:
To turn off bank 10, press 0.
To turn a bank back on, press its number key again. The bar under the
bank number appears.
If you select a bank that does not contain any empty channels, A-FULL
appears instead of AC-XXCH. To enter new frequencies into this bank,
you must delete one or more frequencies stored in it.
3. Press LIMIT. L appears.
4. Use the number keys to enter the lower limit of the frequency range
where you want to find frequencies to store, then press ENTER.
5. Press LIMIT. H appears.
6. Use the number keys to enter the upper limit of the frequency range
where you want to find frequencies to store, then press ENTER.
Note:
If you enter an invalid frequency in Step 4 or 6, the scanner displays
Error. Simply repeat the step.
7. Press Up Arrow to go from the lower to the upper limit, or Down Arrow
to go from the upper to the lower limit. AUTO and the bar under the
currently selected bank number flash on the display.
When the scanner finds an active frequency, it stores the frequency in
the channel number displayed to the left of CH, then continues
searching for more active frequencies and storing them in any
subsequent empty channels. When the scanner fills all channels within
the selected bank(s), it beeps rapidly and displays the last frequency
stored and the number of the channel where it was stored.
Notes:
During auto store, you can manually change the receive mode.
To pause auto store, press AUTO. The scanner displays the last
channel number where a frequency was stored, or ------if no
frequencies are stored. To continue auto store, press Up Arrow
or Down Arrow.
During auto store, the scanner beeps when it reaches the upper limit
frequency, then continues searching from the lower limit frequency, or
vice versa.
8. To stop auto store, press MANUAL. MAN appears.
Band Search
If you do not know of a frequency to store, you can search your scanner's