Filter
Top Products
frequencies that the scanner cannot tune, and try to search in that
range, the scanner beeps and does not search.
If you set a search range that crosses over into a range of
frequencies that the scanner cannot tune, the scanner searches only up
to the limit of tunable frequencies and returns to the starting
frequency.
SCANNING THE CHANNELS
To begin scanning channels or to start scanning again after monitoring a
specific channel, press SCAN.
The scanner scans through all channels (except those you have locked out)
in the active banks.
Notes:
You must store frequencies into channels before the scanner can scan
them.
The scanner does not scan empty channels.
To change the scanning direction, press Up or Down Arrow.
TURNING CHANNEL-STORAGE BANKS OFF AND ON
To turn off banks while scanning, press the bank's number key until the
bar under the bank's number disappears. The scanner does not scan any of
the channels within the banks you have turned off.
Notes:
You cannot turn off all banks. There must be at least one active
bank.
You can manually select any channel in a bank, even if the bank is
turned off.
To turn on banks while scanning, press the bank's number key until a
bar appears under the bank's number.
MOVING FREQUENCIES
Moving a Frequency from a Monitor Memory to a Channel
1. Press PGM.
2. Use the number keys to enter the channel number where you want to
store the monitor frequency, then press PGM again.
3. Press MON. M, the channel number, and CH flash.
4. Enter the desired monitor memory's number (1-40), then press MON
again. The selected monitor memory's frequency appears.