Filter
Top Products
manually.
Keypad does Keylock is turned on. Turn off keylock.
not work.
Error appears Programming error. Enter the frequency
on the display correctly, including
the decimal point.
Keys do not work Undetermined error. Turn the scanner off
or display changes. then on again, or
reset the scanner.
Scanner is on SQUELCH is not Adjust SQUELCH
but will not scan. correctly adjusted. clockwise
(see "Operation,"
Faxback Doc. # 38254.
In the scan mode, Birdies. Avoid programming
the scanner locks frequencies listed
on frequencies that under
have an unclear "Birdie Frequencies"
transmission. on "Frequency Guide,"
Faxback Doc. # 38256
or only listen to them
manually.
RESETTING/INITIALIZING THE SCANNER
If the scanner's display locks up or does not work properly after you
connect a power source, you might need to reset or initialize it.
Important:
If you have problems, first try to reset the scanner. If that does
not work, you can initialize the scanner; however, initializing clears
all information stored in the scanner's memory.
Resetting the Scanner
1. Turn off the scanner, then turn it on again.
2. Insert a pointed object, such as a straightened paper clip, into the
reset opening on the side of the scanner. Then gently press and
release the reset button inside the opening.
Initializing the Scanner
Important:
This procedure clears all information you stored in the scanner's
memory. Initialize the scanner only when you are sure the scanner is
not working properly.
1. Turn off the scanner, then turn it on again.