Filter
Top Products
You can restore the preprogrammed limit search ranges you replaced by
resetting the scanner.
1. Press PGM. PGM appears.
2. Using the number keys, select the number for the search bank where you
want to store a new limit search range.
Note:
To select bank 10, press 1 then 0.
3. Press LIMIT. SRCH BANK, the selected search bank number, and L
appear, and a bar flashes under the selected search bank's number.
4. Use the number keys to enter the lower limit of the frequency range
you want to search, then press ENTER.
5. Press LIMIT.L changes to H.
6. Use the number keys to enter the higher limit of the frequency range
you want to search, then press ENTER.
Note:
If you enter an invalid frequency in Step 4 or 6, the scanner displays
Error. Simply repeat the step.
7. To store more limit search ranges, repeat Steps 2-6.
8. Hold down Up or Down Arrow to search the range(s) you just set.
Direct Search from the Displayed Frequency
You can search up or down from the currently displayed frequency and store
frequencies into channels or monitor memories.
Notes:
You can use the scanner's delay feature while using direct search.
During direct search, you can manually change the receive mode.
1. When you see the frequency where you want to start the search, press
DIRECT.. SRCH, -d-, and the starting frequency appear on the display.
2. Hold down Up or Down Arrow for about 1 second to search up or down
from the selected frequency.
Notes:
To reverse the rapid search direction at any time, hold down Up
or Down Arrow for about 1 second.
To search the selected band upward or downward in small increments