Filter
Top Products
adapter meets these specifications. Using an adapter that does not
meet these specifications could damage the scanner or the adapter.
When you finish using the AC adapter, disconnect it from the AC outlet
first. Then disconnect it from the scanner.
Plug the adapter's supplied 1.3 mm inner diameter/3.4 mm outer
diameter barrel plug into the scanner's PWR/DC 9V jack. Then plug the
adapter's power module into a standard AC outlet.
Warning:
Do not use an AC adapter's polarized plug with an extension cord,
receptacle, or other outlet unless the blades can be fully inserted to
prevent blade exposure.
Using Vehicle Battery Power
To power the scanner from your vehicle's cigarette-lighter socket, you
need a DC adapter (Cat. No. 270-1560).
Cautions:
You must use a DC adapter that supplies 9 volts and delivers at least
200 milliamps. Its center tip must be set to negative, and its plug
must correctly fit the scanner's PWR/DC 9V jack. The recommended
adapter meets these specifications. Using an adapter that does not
meet these specifications could damage the scanner or the adapter.
To protect your vehicle's electrical system, always plug the adapter
into the scanner before you plug it into your vehicle's cigarette-
lighter socket. Always unplug the adapter from the vehicle's
cigarette-lighter socket before you unplug it from the scanner.
1. Connect the DC adapter's supplied 1.3 mm inner diameter/3.4 mm outer
diameter battery plug to the cable, with the tip set to - (negative).
2. Set the adapter's voltage switch to 9V.
3. Insert the barrel plug into these scanner's PWR/DC 9V jack.
4. Plug the other end of the adapter into your vehicle's
cigarette-lighter socket.
Notes:
Mobile use of this scanner is unlawful or requires a permit in some
areas. Check the laws in your area.
If the scanner does not operate properly when you connect a
DC adapter, unplug the adapter from the cigarette-lighter socket and
clean the socket to remove ashes and other debris.
Charging a Rechargeable Battery Pack
Your scanner has a built-in charging circuit that lets you charge a