Filter
Top Products
82
DataTalker Owner’s Manual
The Unit Source Node option specifies the node number of the local node. This number has to
be unique and any number from 0 to 9. Remember that the node number will be used by other
nodes.
The Data Destination Node option specifies the node number of the remote node. This number
has to be unique and any number from 0 to 9.
The Data Source Channel option specifies the source channel to which the destination channel
is communicating with. The Data Source Channel options are 1 or 2 and the default is 1.
The Data Destination Channel option specifies the destination channel to which the source
channel is communicating with. The Data Destination Channel options are 1 or 2 and the default
is 1.
The Voice/Fax Ch. 1 Destination Node option specifies the node number of the remote node for
Voice/Fax channel 1. This number must be unique and any number from 0 to 9. The default for
this option is 1.
The Voice/Fax Ch. 2 Destination Node option specifies the node number of the remote node for
Voice/Fax channel 2. This number must be unique and any number from 0 to 9. The default for
this option is 1.
6.6.2 Quick Setup
The Quick Setup option (Option 6 in the main menu) allows you to configure your DataTalker by
answering a few questions and then following a set of installation instructions. The following
description
Warning: The memory test will destroy all stored configurtions.
Do you wish to continue (y/n)?
If you answer Yes to this question, the next question is presented. If you answer No to this
question, you are returned to the Main Menu.
Is this a home/small office application? (Y/N/Q)
If you answer Yes to this question, the next question is presented.
Will this unit be installed at the main office? (Y/N/Q)
If you answer Yes to this question, the uint is configured for a main office application and
installation instructions are presented for cabling your unit. Refer to Table 6-1 for the main office
cabling procedure.
If you answer No to this question, the next question asks you:
Enter the number to dial the main office:
You need to enter a 7-digit telephone number if you are using the public telephone service. You
do not need to add a hyphen between the first three digits and the last four digits. If you are
interPBX, you need to enter only the 4-digit number. When the telephone number is entered, the
unit will configure itself based on your input and the installation instructions will be presented to
cable your unit. Refer to Table 6-2 for home office cabling procedure.