Filter
Top Products
Chapter 2: Installation & Activation
Multi-Tech Systems, Inc. MVPGSM 9
Cabling Procedure
Cabling involves connecting the MultiVOIP GSM to your LAN and telephone equipment.
1. Connect a power cord to the transformer and to a live AC outlet, and then attach the barrel connector
to the back of the MultiVOIP GSM as shown in the figure below.
Cabling for MVPGSM-2
2. Connect the MultiVOIP GSM to a PC by using a RJ-45 (male) to DB-9 (female) cable. Plug the RJ-45 end of
the cable into the CONSOLE port of the MultiVOIP GSM and the other end into the PC serial port.
3. Connect a network cable to the WAN connector on the back of the MultiVOIP GSM. Connect the other
end of the cable to your network.
4. Attach an antenna to both channel connectors on either side of the MultiVOIP GSM.
5. Turn on power to the MultiVOIP GSM by placing the ON/OFF switch on the back panel to the ON
position. Wait for the BOOT LED on the MultiVOIP GSM to go off before proceeding. This may take a few
moments.
6. Proceed to the Software Installation chapter to load the MultiVOIP GSM software.