Filter
Top Products
Service Manual
Disassembly and Reassembly
3-13
1. Before you remove the Drive Ass'y, you should
remove:
- Rear Cover (see section 3.3)
- Side Cover L (see section 3.4)
Note : When re-fitting the Drive Ass’y tighten the screws
in the order that they are numbered on the base
plate.
2. Remove the six screws securing the Drive Ass'y and
remove it. Then unplug the one connector from the
Drive Motor, as shown below.
3.15 Drive Ass'y
Drive Ass'y
1. Before you remove the Fan, you should remove:
- Rear Cover (see section 3.3)
- Side Cover R (see section 3.5)
2. Unplug the one connector from the SMPS, as shown
below. Then take out the Fan.
3.16 DC-Fan
DC Fan