Filter
Top Products
Service Manual
Alignment & Troubleshooting
4-23
[Jam 1] or [No Cartridge]
Meaning: Paper has jammed inside the unit, or the toner cartridge is not installed.
Solution: Clear the jam. Install the toner cartridge.
Line Busy
Meaning: The remote person did not answer or the line is already engaged.
Solution: Try again after a few minutes.
[Line Error]
Meaning: Your machine cannot connect with the remote machine or has lost contact
because of a problem with the phone line.
Solution: Try again. If the problem persists, wait an hour or so for the line to clear and try
again.Or, turn the ECM on.
Load Document
Meaning: You have attempted to set up a copy or fax operation with no document loaded.
Solution: Load a document and try again.
[Low Heat Error]
Meaning: There is a problem in the fuser unit.
Solution: Check thermostat, thermister contact point & Heating Lamp.
Open Heat Error
Meaning: Thermister is not connected to the main board or contact point is poor at power on.
Solution: Check thermostat, thermister contact point & Heating Lamp.
[Over Heat]
Meaning: The printer has overheated.
Solution: Your unit will automatically return to the standby mode when it cools down to
normal operating temperature. If failure persists, check the ELA HOU-FUSER.
[LSU Error]
Meaning: A problem has occurred in the LSU (Laser Scanning Unit).
Solution: Use TECH mode to test LSU. Replace the LSU
Memory Full
Meaning: The memory has become full.
Solution: Either delete unnecessary documents, or retransmit after more memory becomes
available, or split the transmission into more than one operation.
[No Answer]
Meaning: The remote machine did not answer after all the redial attempts.
Solution: Try again. Make sure the remote machine is OK.