Filter
Top Products
Sample Configurations
Sample Standard Configuration
C-8 NCR S10 Desktop Server User Guide
1. Press [Control] + [A] when the following displays:
Adaptec AIC-7870 BIOS v1.2
<<Press hot key for SCSI Select (TM)
Utility>>
(Refer to the Adaptec SCSI documentation for
additional information about these settings.)
2.
Select SCSI Disk Utilities. Observe that the 2 GB disk
drive and the CD-ROM drive are displayed with the
correct information. If a low-level format on the 2
GB disk drive is needed, perform it now. It is
usually not needed.
3.
Select Configure/View Host Adapter Settings and
set the parameters as follows:
SCSI Bus Interface Definitions
Host Adapter SCSI ID [7]
SCSI Parity Checking [Enabled]
Host Adapter SCSI Term [Low ON/High ON]
Boot Device Options:
Boot Target ID [0]
Boot LUN Number [0]
4.
Select SCSI Device Configuration and set the
parameters as follows:
SCSI Device ID (tab to desired device)
Initiate Sync Negotiation [yes]
Maximum Sync Transfer Rate [20]
Enable Disconnection [yes]
Initiate Wide Negotiation [yes]