Filter
Top Products
Sample Configurations
Sample RAID Configuration
NCR S10 Desktop Server User Guide C-13
connected to the Mylex PCI RAID adapter should
be configured as SCSI ID 0, 1, and 2, for use in a
RAID configuration.
2. Install the SCSI CD-ROM drive in the bottom front
drive bay.
3.
Install the system boot drive (SCSI ID 0) in a 5.25-
inch to 3.5-inch conversion bracket and install it in
the middle, front drive bay.
4. Of the three remaining drives, install one in
conversion bracket and install it in the bottom, front
drive bay. Install the remaining two drives over the
power supply.
5. Connect power cables and a wide SCSI cable to the
two drives over the power supply and the drive in
the top, front drive bay. Connect this wide SCSI
cable to the PCI RAID controller.
6.
Connect power cables and a narrow SCSI cable to
the drive in the middle, front drive bay and the SCSI
CD-ROM drive. Connect this narrow SCSI cable to
the onboard AIC-7870 controller.
7. Install the memory SIMMs in banks 1 and 2 on the
system baseboard (installed in groups of two
SIMMs).
8. Install the PCI Ethernet Adapter in PCI slot 1
(topmost PCI slot).
9.
Install the PCI Token Ring Adapter in PCI slot 2.