Filter
Top Products
5-4 Setting Up a Remote Connection
4.
Select Dial-Up Connection as the connection type and tap Next.
5.
Use the drop-down box to select Internal Modem on COM 4 and tap
Configure.
6.
Select the required port settings and call options. Tap OK.
7.
Tap TCP/IP Settings and configure the required General Settings and
Name Servers. Tap OK.
8.
Tap Next and enter the required dial-up telephone number. Tap
Finish.
Once your ISP connection is established you can configure your
MobilePro to send and receive email through your ISP. Follow the
instructions in “Sending and Receiving Email” and “Activating a
Connection,” later in this chapter, to send and receive email through your
ISP.
For ISP settings, access: http://www.cewindows.net/wce/isp.htm/.
Although not an official NEC web site, this site contains important
information about ISP settings.
Connecting to a Remote Access Server
Once you establish an account with your RAS and gather the necessary
configuration information, you are ready to create a connection on your
MobilePro for your RAS account.
Follow these steps to create a new connection for your RAS account.
1.
Tap Start, Programs, Communication, then select Remote
Networking.
2.
Double tap the Make a New Connection icon.
3.
Enter a name for the new connection.
4.
Select Dial-Up Connection as the connection type and tap Next.
5.
Use the dropdown box to select Internal Modem on COM 4 and tap
Configure.
6.
Select the required port settings and call options. Tap OK.