Filter
Top Products
3. Troubleshooting Functional Failures in Operation
109
9Execute show vrrpstatus command
with "detail" parameter specified to check the
virtual router status.
If the virtual router is set to "Initial," check the following items:
• If the current priority is not set to zero (0), delete the non-operation factors
displayed in the "Admin State" column. (For non-operation factors, see
"Operation Commands.")
• Execute the show logging command to check the log, and if "The VRRP
virtual MAC address entry can't be registered at hardware tables" is displayed,
setting up the hardware MAC address table failed. Delete the configuration for
the current virtual router and reconfigure the configuration with a different
virtual router number, or modify the ID of the VLAN where the virtual router is
set up, and the virtual router may operate. [IP8800/S3600]
If the virtual router is not set to "Initial," check the operation of the remote system
constituting the same virtual router.
No. Troubleshooting Steps and Command Action