Filter
Top Products
ISDN Features
Primary Rate Interface (PRI), Answering Calls
20 ◆ Aspire ISDN PRI Manual
Programming (Cont’d)
➻
22-02-01 : Incoming Call Trunk Setup
Use this option to set the service type for PRI trunks using. Enter 0 (for normal operation) or 3 (to have
the PRI trunk use the DID tables and route on the last three digits a caller dials). There is one item for
each Night Service Mode.
Default Setting: All trunk service types set for normal (0).
➻ 22-03-01 : Trunk Ring Tone Range
Assign Ring Tone Ranges to trunks. Customize the tones within each Ring Tone Range in Program 82-
01. Trunks ring extensions according to the Ring Tone Range selected in 22-03 and the user settings
made with Service Code 820. You may want your ISDN trunks to ring with a unique ring tone.
Default Setting: Pattern 0.
➻ 22-04-01 : Incoming Extension Ring Group Assignment
To have PRI trunks ring extensions, use this program to assign extensions (up to 32 max.) to Ring
Groups (1-100). You must also assign the PRI trunks to the Ring Groups in Program 22-05 below. See
How the Telco Handles PRI Trunks on page 12 for more.
Default Setting: All extensions are in Ring Group 1.
➻ 22-05-01 : Incoming Trunk Ring Group Assignment
To have PRI trunks ring extensions, assign trunks to Ring Groups (Ring Groups =1-100, 102 = In-Skin/
External Voice Mail, 103 = Centralized Voice Mail). Normally, you should assign a trunk on a PRI PCB
to the same Ring Group. You must also assign extensions to Ring Groups in Program 22-04-01 above.
See How the Telco Handles PRI Trunks on page 12 for more.
Default Setting: All trunks are in Ring Group 1.
➻ 22-06-01 : Normal Incoming Ring Mode
For each extension in the Ring Group assigned in 22-04-01, indicate if trunks should ring (1) or not
ring (0).
Default Setting: All extensions ring.
➻ 22-08-01 : DIL/IRG No Answer Destination
If an incoming PRI trunk call rings longer than the DIL No Answer Time (Program 22-01-04), it routes to
the Ring Group you specify in this option (Ring Groups=1-100, In-Skin/External Voice Mail = 102, Cen-
tralized Voice Mail = 103).
Default Setting: Calls reroute to Ring Group 1 based on the timer in Program 22-01-04.
➻ 22-11-01 : DID Translation Table Number Conversion
Specify for each Translation Table entry (2000):
● The digits received by the system (eight max.)
● The extension the system dials after translation (24 digits max.)
● The name that should show on the dialed extension’s display when it rings (twelve charac-
ters max.)
● The Transfer Target-1 and 2
● If the Transfer Targets are busy or receive no answer, those calls are transferred to the final
transfer destination (Program 22-10).
● Operation mode