Filter
Top Products
64
3.OPERATION
This feature allows you to select two ways to store settings; auto-
matically and manually.
After “Enable” is selected in the Auto Data Store menu, all projector
settings are stored in the projector's memory automatically. To set
this feature, proceed as follows:
1 Use the CURSOR or button to select the “Auto Data Store”
item on Page 2, then press ENTER to display the “Auto Data
Store” menu.
■ Auto Data Store
-Setting Mode-
1. PJ Orientation
2. Default Source Select
3. S-Video Mode Select
4. Video System Select
5. Auto Data Store
6. Option Terminal Speed
7. Uniformity Switching
Setting Mode
PJ Orientation
Default Mode Select
S-Video Mode Select
Video System Select
Auto Data Store
Option Terminal Speed
[Ceiling/Front ]
[S2 ]
[ Disable ]
[38400 BPS ]
[Disable ]
[Disable ]
Manual
NTSC3.58
Default
INPUT-A
S-Video
Uniformity White
Edge Blend.
2 Use the CURSOR or button to select either “Disable” or
“Enable” and then press ENTER.
Items to select
• Disable .... Projector does not store the settings automatically.
• Enable ..... Projector stores the settings automatically.
Automatic storing data is done when any one of the following
procedures is performed:
• Pressing the END button several times returns the adjustment
screen to the source screen.
• One input is switched to another.
• The projector is turned off.
• Every 10 minutes.
NOTE: After “Disable” is selected in the Auto Data Store menu,
the settings will not be stored in the memory unless you select
“Yes” in the “Store ?” menu.
Disable
Enable
Auto Data Store