Filter
Top Products
Advanced Settings
112
D6200 WiFi DSL Modem Router
Wireless repeater. The WiFi DSL modem router sends all traffic from its local wireless or
wired computers to a remote access point. To configure this mode, you have to know the
MAC address of the remote parent access point.
The D6200 WiFi DSL modem router is always in dual-band concurrent mode, unless you turn
off
one radio. If you enable the wireless repeater in either radio band, the wireless base
station or wireless repeater cannot be enabled in the other radio band. However, if you
enable the wireless base station in either radio band and use the other radio band as a
wireless WiFi DSL modem router or wireless base station, dual-band concurrent mode is not
affected.
For you to set up a wireless network with WDS,
the following conditions have to be met for
both access points:
• Both acce
ss
points have to use the same SSID, wireless channel, and encryption mode.
• Both access
points have to be on the same LAN IP subnet. That is, all the access point
LAN IP addresses are in the same network.
• All LAN devices (wired and wireless computers) have to be configured to operate in the
same LAN ne
twork address range as the access points.
Wireless Repeating Function
Use the Wireless Repeating Function screen to view or change the wireless repeater
settings.
To view or change the wireless repeater settings:
1. Select ADVA
NCED > Advanced Setup > Wireless Repeating Function.
2. Configure the following settings: