Filter
Top Products
Chapter 7: Maintenance | 235
GS716Tv2 and GS724Tv3 Software Administration Manual
Note: After activating an image, you must perform a system reset of the
switch in order to run the new code.
4. To remove the selected image from permanent storage on the switch, select the Delete
Image check box. You cannot delete the active image.
5. Click Cancel to cancel the operation on the screen and reset the data on the screen to the
latest value of the switch.
6. Click Apply to apply the settings to the switch.
Dual Image Status
You can use the Dual Image Status page to view information about the system images on the
device.
To display the Dual Image Status page, click Maintenance > File Management Dual Image
Dual Image Status.
The following table describes the information on the Dual Image Status page.
Field Description
Unit The unit ID of the switch is always 1.
Image1 Ver Displays the version of the image1 code file.
Image2 Ver Displays the version of the image2 code file.