Filter
Top Products
3G Broadband Wireless Router MBR624GU User Manual
Managing Your Network 4-5
v1.0, January 2009
Table 4-1. Router Status Fields
Field Description
Firmware Version This field displays the router firmware version.
HSDPA
(High-Speed
Downlink Packet
Access)
Modem Identity Shows the modem in use.
Modem sw version The software version of the modem.
Modem driver
version
The driver version of the modem.
IMSI International Mobile Subscriber Identity. SIM card identity.
IMEI International Mobile Equipment Identity.
Unique identity of the 3G modem.
Operator The ISP for the broadband wireless network.
Network mode The mode of the current network the 3G modem is connected to.
This is dependent on coverage and distance from the cell site.
WAN Port Connection Status The status of the Internet connection.
IP Address The IP address used by the modem. If no address is shown, the
router cannot connect to the Internet.
Protocol The protocol for the Internet connection, which is PPP (Point-to-
Point).
IP Subnet Mask The IP subnet mask used by the router’s USB port.
Gateway IP Address The IP address used by the router.
Domain Name
Server
The DNS server IP addresses used by the router. These
addresses are usually obtained dynamically from the ISP.
LAN Port MAC Address The Ethernet MAC address used by the router’s LAN port.
IP Address The LAN port IP address. The default is 192.168.0.1.
DHCP • Off: The router will not assign IP addresses to PCs on the
LAN.
• On: The router assigns IP addresses to PCs on the LAN.
IP Subnet Mask The LAN port IP subnet mask. The default is 255.255.255.0.
Wireless Port
(See “Manually
Configuring Your
Wireless Settings”
on page 2-4.
Name (SSID) The service set ID, also known as the wireless network name.
Region The country where the unit is set up for use.
Channel The current channel, which determines the operating frequency.
Wireless AP Indicates if the access point feature is disabled or not. If not
enabled, the Wireless LED on the front panel will be off.
Broadcast Name Indicates if the router is configured to broadcast its SSID.